奉化市四口三位手转阀/亚德客4HV230-08

1, the four mouth of the three hand rotary valve, there are three central functions to choose from;

2, reversing light, feel good, accurate positioning;

3, the effective flow area, small pressure loss;

4, there are two types of panels and the bottom of the installation options available, the panel installed with the installation nut.

1、四口三位手转阀，有三种中央功能可供选择；

2、换向转动轻盈，手感好，定位准确；

3、有效流通面积大，压力损失小；

4、有面板及底部两种安装形式可供选择，面板安装附安装螺母。
 

1, pay attention to check before using the components in the transport process is damaged, and then install;

2, please note that the installation of gas flow direction and the right type of nozzle. The media must be filtered through 40 M filter;

3, please note that the installation conditions are in line with the technical requirements (such as voltage, frequency of action, working pressure, the use of temperature range, etc.);

4, pay attention to the direction of gas flow in the installation, P position air inlet, A (B) working port, R (S) position air inlet;

5, try to avoid the use of vibration environment, and pay attention to antifreeze measures at low temperature;

6, the connection of the pipeline, pay attention to the tape can not be more than the end of the interface teeth, pay attention to clear the pipe joints dust, iron filings and other dirt, to avoid impurities or foreign body into the valve body;

7, please pay attention to dust, the exhaust port is recommended to install silencer or muffler throttle valve. When not in use should be installed in the inlet and outlet of the dust jacket.

安装与使用：

1、使用前注意检查组件在运输过程中是否损坏，然后安装；

2、安装时请注意气体流动方向及接管牙型是否正确。使用介质必须经过40μM滤芯过滤；

3、请注意安装条件是否符合技术要求（如电压、动作频率、工作压力、使用温度范围等，）然后安装使用；

4、安装时注意气体流动方向，P位进气口、A（B）位工作口、R(S)位进气口；

5、尽量避免在震动的环境下使用，并注意低温下的防冻措施；

6、连接管路时，注意止泄带缠绕不可超过接口牙端面，注意清除管路接头内的粉尘、铁屑等脏物，避免杂质或异物进入阀体内；

7、请注意防尘，建议排气口安装消声器或消声节流阀。拆下不用时应在进、出气口装防尘套。